DG-BG4100N User Manual
105
The procedure for manipulating a mapping group is as follows:
Step 1 Select Enable to enable this function.
Step 2 Select a group from the table.
Step 3 Select interfaces from the WAN and LAN interface list and add them to the
grouped interface list using the arrow buttons to manipulate the required
mapping of the ports.
Click Apply Changes to save the changes.
3.6.4 IP QoS
Choose Advance > IP QoS, and the page shown in the following figure appears. Entries in
the QoS Rule List are used to assign the precedence for each incoming packet based on
physical LAN port, TCP/UDP port number, source IP address, destination IP address and
other information.
Step 1 Enable IP QoS and click Apply to enable IP QoS function.
Step 2 Click add rule to add a new IP QoS rule.
Comments to this Manuals